Rumble Stripes

Rumble stripes are grooved into the pavement edge for roadways with no paved shoulder.

When the edge line pavement marking is painted through the rumble strip, the grooved surface of the rumble stripe facing the driver can provide a near-vertical surface, which enhances edgeline pavement marking visibility at night and during rainy conditions.

A study by the Center for Transporation Research and Education (CTRE) at Iowa State University (Hallmark et al. 2011) evaluated the effectiveness of rumble stripes on rural two-lane roadways in Iowa. Rumble stripes were installed and monitored at seven sites. The project involved milling narrow width (4–6 inch) rumble strips that were a maximum of approximately 5/8 inch deep along the pavement edge of selected roadway sections. The treatment was applied to both curve and tangent sections.

A review of sections after two years of winter maintenance indicated that the pavement markings were performing better within the rumble stripe themselves as compared to sections of flush pavement. This indicates the rumble strips can help preserve some portion of the marking during winter maintenance.

The study also found that average offset from the lane center improved by 0.7 feet during daytime conditions and by 0.9 feet during nighttime conditions. This suggests drivers improved lane keeping with installation of the rumble stripes.

Two studies were conducted in Iowa to evaluate edgeline rumble stripes (Phase I and Phase II). More information is provided in this tech transfer summary, which summarizes information about edgeline rumble stripes.

Reference

Hallmark, Shauna, Tom McDonald, and Robert Sperry. Evaluation of Rumble Stripes on Low-Volume Rural Roads in Iowa-Phase II. Center for Transportation Research and Education, Iowa State University, 2011.

Image: Four-inch edgeline rumble stripe placement on a rural highway in Iowa

Four-inch edgeline rumble stripe placement on a rural highway in Iowa (Neal Hawkins/Institute for Transportation)

Image: Wear of rumble stripe two years after placement

Wear of rumble stripe two years after placement (Shauna Hallmark et al./Institute for Transportation)


Development of this website was financed in part through funds provided by the Iowa Department of Transportation and Federal Highway Administration state planning and research funding.

The contents of this website reflect the views of the authors, who are responsible for the facts and the accuracy of the information presented herein. The opinions, findings and conclusions expressed in this website are those of the authors and not necessarily those of the sponsors.

The sponsors assume no liability for the contents or use of the information contained in this website. This website does not constitute a standard, specification, or regulation.

The sponsors do not endorse products or manufacturers. Trademarks or manufacturers' names appear on this website only because they are considered essential to the website's objective.